Construction Line Edit All Command

Lets you change the color and other attributes of all construction lines that are in your current view ( Modeling ) or on shown layers ( Drawing Editor ).
  • Step-By-Step
  • Tips and Tricks
  • Related Tools

The Construction Line Edit window:

Clicking a link takes you to the Construction Line Edit window help page.

To open this window using Construction Line Edit All :

Method 1 : Click the Construction Line Edit All icon, which is pictured above. The icon can be found on the Layout page > Layout section.

Method 2 : Invoke Construction Line Edit All using the Find Tool by searching the command name and clicking the Construction Line Edit All icon, which is pictured above.

  • The Drawing Editor does not support finite construction lines, but you can use this tool to move all construction lines that are visible in your current drawing to a drawing layer of your choice.

    • Drawing Editor only
    drawing layer the construction lines are drawn on.

    • Construction lines on drawings are not plotted when those drawings are printed.
    • In multi-user Modeling environments, any construction lines that are in your current erection view can be seen by you only, and therefore any changes you make to them will be seen by you alone. In addition to the ability to change the color of construction lines, you can make them " Finite " or " Finite. " When " Finite line " is checked, each construction line terminates at the two points used to add it. Construction lines added by locating a point then specifying an angle ( ANGL ) are always infinite and cannot be changed to finite.
    • Since there are some fundamental differences between construction lines in a 2D and 3D environment, the options shown on the Construction Line Edit window depend on whether you are in the Drawing Editor or Modeling .